Jump to content


monoRAIL

Members
  • Content count

    6
  • Joined

  • Last visited

Community Reputation

73

1 Follower

About monoRAIL

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. monoRAIL

    77279 Narthrax defends her kill

    Thanks for the comments everyone! 1 - 3D Studio Max (although Blender would be just as good), printed on a Wanhao Duplicator i3 printer. 2 - It's a Tamiya A4 cutting mat. This one: 3 - Yes, I pinned the rock to the base. After supergluing it, I drilled through the plastic rock into the wooden base and used paper-clip pins glued into the holes. I also pinned the wings and feet on the model.
  2. monoRAIL

    77279 Narthrax defends her kill

    Thank you, I didn't know about this contest. Would this count as a diorama because it has a 2nd model on it?
  3. monoRAIL

    Jungle Photo Backdrop Board Terrain by Glitterwolf

    Very creative! I usually use paper and cardboard for the backdrops in my photos.
  4. monoRAIL

    77279 Narthrax defends her kill

    Nice idea, I haven't used water effect paste before. I'll have to check it out.
  5. monoRAIL

    77279 Narthrax defends her kill

    Here's my attempt at Narthrax in a Smaug inspired color-scheme. She's defending her kill which is hidden at the back of the base. The base is a 10cm MDF board with some 3D printed rocks attached to create a cross-section effect on the edge of the base. I coated the 3D printed parts in plaster filler to add texture and used some cork, gravel and sand to finish the base. The horse parts are removable to make a less scary version. They're made from some old citadel horse and skeletal horse models. The horse head has a small metal pin on the side that inserts into a hole in Narthrax's hand. The ponies in the last shot are from Impact Miniatures Chibi Pony set.
×