Recently Browsing 0 members
No registered users viewing this page.
So today when I started airbrushing, I noticed that after I sprayed a bit the pressure on the tank was dropping, which made it difficult to get an even coverage. I'd start at around 15psi, and it would hold for a couple seconds, then drop steadily until it was down at 5psi. Turning up the pressure did not help, it still dropped psi. I took out the needle and checked and cleaned it and the rest of the ab, then tried just shooting air through, without needle or anything but the nozzle lever. Same result. Seals are airtight at least until I start shooting air through. I have a Paasche TG-3F, bought it with the compressor in a package deal, compressor has a humidity filter on it.
EDIT: Just noticed that while air is going through the airbrush, adjusting the pressure does nothing at all. I can turn it up or down and it stays at 5psi. Unless I reduce the pressure below 5psi, then it goes down. Adjusting the pressure when I release the airbrush changes psi normally.
Finished Cthulhu on Saturday, I think I'm learning to overcome my fear of highlighting too far, I still didn't go as light as people said I should. Some say you can go practically to white, but I am very hesitant to try that. I think I've made progress though. C&C welcome!
Harsh Lighting, to show detail----
And WIP thread if anyone is interested...
Hey guys. I'm back after having my wisdom teeth removed :/ nasty surgery had to have some recovery. But I started painting again and I was wondering; am I getting speckling here? It used to be really bad but I diluted down a touch and I think it's better. Could use some help.
So as a lot of folks around these here electronic parts know, I have barely hobbied since ReaperCon, due to brain weasel infestation...
So for the past few days, I have tried to ease my way back in by working on 'risers' for my display case...
These are chunks of blue insulation foam, cut to fit on my table saw (what a mess it makes!)
Then sprayed Grey with Stynylrez primer through my airbrush.
Started life as the 'wings' of an entertainment center, and I added the LED lights scavenged from work...
Left side is still in progress... (Top to bottom)
A lonely DDS2
a bare section that I sprayed the foam for tonight (The ex suggested that I put figures with a special value to me in it, old characters and such, likely, exchanges and gifts will end up in there as well, and the first 25mm mini that I ever painted. Rest will be underground critters and whatever else I can cram in there to get them off my bookcases....)
Frostgrave terrain and warbands...
Top is Demons and devils, Undead and pillars, and some of my medal wining Reapercon stuff
Middle is some bigger things...
Bottom is Giants and wilderness type critters....
Thanks for taking a peek!
Who's Online 37 Members, 2 Anonymous, 0 Guests (See full list)
- Froggy the Great
- Lord of the Dish Pit
- Knight of the Dinner Table
- Darsc Zacal
- Reverend Shartan