Jump to content

paintybeard

02835 Jolie, Frostgrave apprentice

Recommended Posts

1 hour ago, Glitterwolf said:

Awesome pair!

 

 

 Unfortunately I think that may be EXACTLY what he is saying to her...

  • Like 1
  • Haha 3

Share this post


Link to post
Share on other sites
13 hours ago, wdmartin said:

You must have added that quill pen; unless there's a Jolie variant I'm not aware of.

 

Yes, I glued on a feather from the spares box as a quill. The poor girl isn't a very good wizard and is scratching her head in puzzlement.

12 hours ago, 72moonglum said:

Very nice job on both of them, and the old school size/scale creep doesn't seem to interfere much on these two.

 

Thank you, she is tall and leggy whereas he is ancient and wizzened...

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By Kev!
      Howdy,
       
        I'm getting something...
       

       
      Kev!
      P.S. Sooth, I say!
    • By Kev!
      Howdy,
       
          It's a Trap!
       

       
      Kev!
    • By Kev!
      Howdy,
       
          Who ya gonna call?
       

       
      Kev!
    • By Brianuk
      Have put together some rough ground by sticking some resin basing bits from Scibor ("elven ruins") with foam off cuts and rocks from other models. Then just started painting the whole thing as basically a rockery. The idea is to add a bit of snow effect, and some lichen etc or trees when it is on the table. 
       
      I have then started on a set of ruined buildings for Frostgrave. These are just foam pieces rolled with a green stuff world roller and stuck onto a wooden orange box left over from Christmas. As I shop at over priced supermarkets this was made out of some quite serviceable MDF/wood. It had holes cut into it already which I tried to use in the terrain. Am using balsa to stick ledges onto the inside and balsa floorboards on top. 
       
      Will add more grime and then some snow effect. Will also think about using some water effects in the well/drain. 
       
      Then, I made some little notice boards (as am a fan of Witcher 3) and my wife made some posters for them. 





    • By Brianuk
      I put together this Barrow from xps foam and a decopage cardboard treasure chest lid. I used a greenstuff world roller to texture the doorway and landing outside. It is all stuck together with super glue. 
       
      I was keen to make sure that there were flat areas for based minis in the front and at the rear. My minor mistake was making the rear plinth/hill a bit too narrow after sticking on the rear wall section, hence cutting out a slit. 
       
      When all the glue has dried I will prime it with a mix of mod podge and black paint. Then I will flock the top. I need to decide whether to make this snowy or green. I think that snow will cover more model making sins... 



  • Who's Online   16 Members, 0 Anonymous, 0 Guests (See full list)

×