Search the Community
Showing results for tags 'flashing'.
Okay! So I've primed a few figures and I'm ready to go. The problem is, I notice that on one of my figure's very delicately muscled arm, there's a flashing problem: her bicep is bifurcated! I'd prepped this one earlier before priming, but like everything else, you notice the flaws better after priming. The problem is that I'm finding it impossible to use a file, hobby knife, whatev to clean up her lines. If I use the file, it won't fit into the area I need to get to, and actually starts to wear away on a spot away from where I'm trying to reduce the flashing. The same problem happens with the hobby knife, and I'm worried I'll give her a flat bicep. So... with that said, to what degree do you clean up casting flaws like this that go slightly beyond ordinary flashing? Do you rub greenstuff on the area and try to even out the miscast area and smooth as best as possible? Do you file away until one arm is skinnier than the other? Do you just leave it be and pray that nobody notices? What are the best techniques for getting rid or covering up flashing/miscasts/etc? For reference, this is the model I'm working on: http://www.reapermini.com/OnlineStore/blade%20sister/sku-down/14645 It's on her right bicep and I'm probably being overly obsessive about it, but I want to get better at my prepping. I should also note that there are a few occlusions in this model as well. Nothing too serious, but there is a distinct divot on one of her boots and a couple in her hair. They're small, but they're there. I guess I'm just OCD over this stuff, or Varaug was just a very good cast. Thanks for the advice!