Search the Community
Showing results for tags 'Butchers Guild'.
Found 1 result
I picked up a couple of starter sets for Guild Ball a while back but I've been in a bit of a hobby funk for the past month. I'm hoping to break out of it by getting these guys started: This is my first foray into a miniatures game along with my serious attempt and basing some minis. First up is Ox: I just put some green stuff into the bases slot and stuffed the metal tab in there with it. I covered it up a bit and let it set overnight. Then I glued some GF9 basing grit to the base with some Elmer's Glue and after it set I used some watered down glue to seal the grit on there. After letting everything set overnight again I primed him tonight with Reaper's Grey Primer. Did pretty much everything the same with the ball except I just made a hole in the green stuff with the little metal piece sticking off of the ball and super glued it to the base when the green stuff dried. I think everything went fairly well and I plan on getting started painting them tomorrow night.