Search the Community
Showing results for tags 'Stripping'.
Found 4 results
I have been away from painting and these boards for a while. I recently got back into painting and started with some of the bones 3 ogres. I made a rookie mistake with bad lighting and decided they had to go in the Simple Green bath. The ones that I based coated with brown cleaned fairly well.The armored ogres had Vallejo Coal Black and the stuff will not come off after 36 hours.That is not even a primer, just black model paint. So has anyone had this problem? Do I need to step up the cleaning solution to acetone free nail polish remover? Brake fluid? Has anyone tried nail polish remover or brake fluid on the Bones? how does the plastic react?
A question for the greater reaper hive mind: I had 8 figures in a simple green bath...which I forgot about for many months. The archer left torso has a divot, as does the center torso ('83). Chick in right hand side(97) has her entire rear end gone. Figure center is the arm from a Pillager mech(93). A striker light tank (88?) has a similar divot formation on the cockpit and the turret. There was a magnet in the arm where the black hole is, the brown discoloration was not paint. Lead rot? Or did I unleash a hellish chemical reaction?
Hey, all. I posted before in the stripping guide but figured it'd be best not to eff it up anymore. I've started trying to strip some lead (supposedly pewter, but the models are lead, from my research) miniatures from the 80's. I was really excited about the pieces, and I got a great deal, but they were previously painted--a kid's work, from the looks of it. I've never dealt with this before, but I'm guessing they're enamel paints. They're very shiny and glossy to look out, very smooth to the touch. I was ready to blast in with acetone and strip the mothas down. Only it's not working! A couple pieces on a six-hour soak followed by good scrubbing with a tooth brush has yielded little result. I decided to give them longer, added in more miniatures and let them go overnight. twelve-hour and eighteen-hours scrubs have produced little to no mentionable results. The acetone's turned murky, so something's happening, but I'm not losing the paint in any significant way. My understanding was that the acetone should be quick and effective, so obviously I need to try something else, right? I'll keep giving the minis currently soaking in acetone more time. Should I periodically change the acetone out, though, or stick with what's in there? What else might be good for removing tough old paints? We're looking at the toughest of the tough, apparently. I know a lot of folks swear by Simple Green, so I picked a jug up and have started soaking several minis in it. My understanding is that it can take 24 hours to tell whether it's really doing it, though. So I'll probably just leave it until tomorrow morning (maybe check it tonight, just to see). Sound about right? This a good option under the circumstances? I've also got a can of lacquer thinner. I'm going to try it this afternoon, most likely. I'm good with handling chemicals (licensed for all manner of nasty stuff thanks to my job), but still not really excited about it. Feel like this is hedging toward the nuclear. I'd love advice about these methods, and I'm certainly open to other suggestions. Any wisdom y'all have is greatly appreciated.