Recently Browsing 0 members
No registered users viewing this page.
These scenery bits are from the Bones 2 and 4 kickstarters respectively. I did them quick in my go-to rock paint scheme. An uneven coat of dark greengrey over a solid black undercoat, followed by a heavy drybrush with a sandy yellow, and finished with a lighter drybrush of offwhite. Quick and easy! The colours give a much more satisfying rock finish than just using the typical monochrome greys.
Too bad the colours are not really showing properly up in the photos.
On each end are the Pillars of Good and Evil from Bones 2, the rest is the subset "Grave Things" from the Bones 4 core set.
The Pillar of Evil to the left, the Pillar of Good to the right.
They are made in the older Bonesium PVC material, and as you can see it shows. No amount of the hot water trick is going to correct that warped listing there. I have not seen the metal versions so I cannot compare them with the Bones or even say that the metal ones do no list in the same way (though I doubt that they do.)
I would have thought it be more fitting if these came as a pair of each and not just one of each, but there we are. They are sold as single packs in retail anyway.
77246 Pillar of Good
77247 Pillar of Evil
Reaper Miniatures, Bones 2 KS 2013 Core set, Dungeon Décor subset
Sculpted by Sandra Garrity
30mm round lipped based
available from reapermini.com
These are from the subset "Grave things" in the Bones 4 Core set. Listing again! I was unsuccessful in trying to unbend the batty one as it bent back over time. Should have left it longer in the hot water. Oh well.
Again, they should have come in a pairs of each.
It seems Bones really is not the best material for boxes with square corners and all that...must be that corrupting influence of the Warp.
This one is OK and untainted by the warp though. The loose books are a nice touch.
Tiny glyphs and imaginary writing that looks much better (and way more impressive) when not magnified, as does most of my painting. The page is actually about 10mm wide. The black symbols and all that are done with .01mm and .02mm pens.
klatoo...berata....nih*cough cough* Ok, then, thats it! *takes book, thunder rumbles* Hey wait a minute! I said the words! I did!
B4Core #126, #127, #128 and #129 Grave Things
Reaper Miniatures, Bones 4 KS 2017
40mm 3D-printed round lipped base on the statues
should be available from reapermini.com some time in the future
Last night I did a quick paint of a couple of minis while my wife painted a paint-by-numbers. I did a little bit of extra work this morning, and had some equipment malfunctions that damaged the minimal face I did paint. As this was all about a quick job, I only fixed the problem, but didn't redo it.
The WIP is linked and photos will follow shortly in a separate post (I'm currently trapped by feline).
Who's Online 23 Members, 2 Anonymous, 44 Guests (See full list)