Jump to content

Custom 3D Printed Dwarf Paladin


evilcoatrack
 Share

Recommended Posts

  • Replies 10
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Stuff like PLA isn't all that brittle, really. It's not as flexible as ABS, but unless you really abuse it it won't break easily. 

That is assuming that the printer that was used is correctly set up. Print at too low temperature and all bets are off...

(A lot of the bad rep 3D printed objects have gotten is from poorly handled temperatures in the early days)

 

I'm printing DragonLock terrain pieces (2x2" modules by Fat Dragon Games), and I print mine with 0.8mm thick sidewalls, 0.5mm top and bottom and no internal support structures. I'm pretty certain it will hold up what most gamers will expose them to of abuse.

post-14703-0-30401000-1450630054_thumb.jpg

 

I just give the stuff a coating of Vallejo gray primer before adding the acrylics paints.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...