Franck Buck (80033)

[nervisfr]

hey ,

 

i would like to get a comparison scale for Franck Buck with some of the most common 28mm on the market like Wargame Foundry, Crusader, Artizan, Coppelstone, etc...

 

 

The main problem is the scale different between several miniatures in the Reaper range. For example, the dwarfs, when you have to mix them with other manufacturers is sometime difficult.

 

thank you for your interest

 

regards

Eric

[etherial]

See those little triangles on the righthand side? We call them Bryangles. The lower one is half an inch, the top one is one inch.

[Doug Sundseth]

Also, 1/2" = 12.7mm, 1" = 25.4mm.

 

See those little triangles on the righthand side? We call them Bryangles. The lower one is half an inch, the top one is one inch.

[wargamer]

just a rough eyeball measurement but should be close to 40mm to the top of his hat.

[Inarah]

Artizan and Copplestone tend to be a little smaller/slimmer than Reaper, but not so much that you can't mix them on the table.  Wargame Foundry is *shorter* than almost any other line I know, but compares well in bulkiness of the figure. 

[nervisfr]

thank you guys for your comments 

 

i have some Chonoscope figurines who are mixable with Coppelstone and Street violence from Foundry....