Jump to content

Secret Weapon - Tablescapes Dungeons: Mines


Reaperbryan
 Share

Recommended Posts

1 hour ago, Erk said:

Thanks for that heads up Chris!

 

Some of these pieces are big enough that besides hot water reforming, it might be possible to put some sturdy wires in and bend them to hold the shape. I do that with limbs and things sometimes.

 

 

Hmm... that’s not a bad idea.  Though I think the main problem is in the thin flat area between the two rocky outcropping, and any wire that would fit in there might not do much.  I could drill into the rocks each side of the gap, and run a big wire across it, and then just paint it like somebody put an iron bar across to provent things from crossing into the track.  

 

I think I will try the boiling first, and if that doesn’t work,  I’ll experiment  with some coat hanger wire.

  • Like 1
Link to comment
Share on other sites

  • Replies 639
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

8 minutes ago, Chris Palmer said:

 

 

Hmm... that’s not a bad idea.  Though I think the main problem is in the thin flat area between the two rocky outcropping, and any wire that would fit in there might not do much.  I could drill into the rocks each side of the gap, and run a big wire across it, and then just paint it like somebody put an iron bar across to provent things from crossing into the track.  

 

I think I will try the boiling first, and if that doesn’t work,  I’ll experiment  with some coat hanger wire.

 

If you have to go there, you might want to try music wire instead (though make sure you use the right tool to cut it). It's a hardened steel, so it's less likely to bend on its own over time.

  • Like 2
Link to comment
Share on other sites

2 hours ago, HornedTurtle said:

I received a my pledge but the bridge set was missing, does anyone know if maybe that was sent in a separate package of is that's something that was delayed?  I emailed them just to be safe.

 

I got my bridge set but was missing the Troll Hole set.

  • Like 1
Link to comment
Share on other sites

2 hours ago, HornedTurtle said:

I received a my pledge but the bridge set was missing, does anyone know if maybe that was sent in a separate package of is that's something that was delayed?  I emailed them just to be safe.

 

My Bridge sets came in the same shipping box as my Core sets. So I don’t think they are shipping then separately. 

  • Like 2
Link to comment
Share on other sites

2 hours ago, HornedTurtle said:

I received a my pledge but the bridge set was missing, does anyone know if maybe that was sent in a separate package of is that's something that was delayed?  I emailed them just to be safe.

 

Emailing them is the way to go. They didn't mention a delay for any item other than the stair sets that they didn't add to the early shipments. Probably just overlooked adding it to your box. 

  • Like 1
Link to comment
Share on other sites

1 hour ago, dice4hire said:

Update posted with quite a lot of info

Unfortunately the AU distributor is rather full of it,  the convention referred to is one of the smaller ones,  and they'll  only have a minimal stand there (unless something has changed since i last looked at the trader map for wintercon). I think they're just too busy with other project fulfillment

  • Like 1
Link to comment
Share on other sites

Regretably at least half the Australian friendly kickstarters I'm aware of use this particular company to send things out. As was pointed out to me in the comments there was another convention this weekend just gone that i wasn't aware of.  My perceptions of the company are biased due to other dealings I've had with them outside of kickstarter fulfullment.

 

Once they get things running with kickstarters they are usually pretty good

  • Like 1
Link to comment
Share on other sites

I'm getting a bit disappointed. I thought it was a very nice solution to send those parts (stairs?) that they did not have enough of to Europe and AUS so that those folks (me included) would not have to wait that long. Then the problem with the paints happened and since then we have no idea where we stand, how close we are to shipping.

  • Like 1
Link to comment
Share on other sites

I just got a delivery notice - as I was leaving town.

someone will be tearing into the package this evening but it won’t be me. Chances of it not being stolen before I return are close to zero.

::(:

Edited by vulture
  • Sad 5
Link to comment
Share on other sites

55 minutes ago, vulture said:

I just got a delivery notice - as I was leaving town.

someone will be tearing into the package this evening but it won’t be me. Chances of it not being stolen before I return are close to zero.

::(:

 

is there anyone you know that can go pick it up and keep it safe?

  • Like 2
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...