Recently Browsing 0 members
No registered users viewing this page.
Hello everyone, now that my Perils of the Underworld diorama is built, I'll post here the detailed steps of my paintings sessions. The Work in progress of the display base can be found HERE.
Let’s start the painting section with a hack to save time. When I paint a large surface, typically a terrain piece, I apply paint straight on the surface and spread it with a large brush. It’s way faster, since I don’t have to go back to the palette each time to reload the brush bristles. Here I’m using a #8 flat brush.
As a base coat for the display I used 09660 powderburn brown.
I filled the gaps and hard to reach areas with a #1 brush. At this step, I’m using old brushes as it doesn’t matter if the bristles are sharp or not.
I then applied a dry brush of 09028 muddy brown all over the base.
I dry brushed of 09028 muddy brown on the upper part of the 03602 stone lurker and started painting the bat as well. The bat is from the 02018, Familiar Pack I. I used the same colors on the bat's perch that those I used on the display base. I painted the bat body in 29843 solid black.
Next, I started layering the bat wings with military grey (this out of production color can be substituted by 09438 tempest grey).
Here’s the picture I referred to for the bat wing colors.
For the bat fur, I used 09059 aged bone and the fingers were painted with a mix of 29839 maroon red and 09059 aged bone.
Even if it will be impossible to see the back side of the bat when it would be attached to the display base, I painted it anyway.
17mm wingspan ready to take off. I applied a 29822 suntan flesh highlight on the stalactite, then a mix of 29822 suntan flesh and 09059 aged bone for the final highlights.
Here’s the back side completed with a final 29822 suntan flesh highlight.
Here you go, that’s it for today. Spread your wings and go explore the Underworld.
Good day everyone, I will share here my progression on a project I wish to do for a long time. I already know all the parts I'll be using for this diorama. Starting with the carefree 03082 Ingrid sculpted by Derek Schubert (I'm converting her as a svirfneblin prospector), accompanied by her faithful familiar the 14453 hunting cat sculpted by Sandra Garrity. They are taken as prey by a 03602 stone lurker sculpted by Kevin Williams. I will also add a 02018 bat from the familiar pack 1 hanging somewhere on the rock wall. I already worked on Ingrid. I removed the base and give her a pickaxe. I made her tool with a paperclip and a piece of scrap metal. This all-project idea started with the gemstone she’s holding in her left hand.
During my Shelf of Shame Project I started with the fairy. Since there is only room for one project on my wet palette, this one had to take the back seat during RVE. Today I finished another project, at least as far as the palette is concerned, so I can finally continue with my little fairy. Every aspect of this project was created by rolling dice.
For everyone interested, here is a somewhat elaborate summary of part one:
During weekend I usually put down my brushes. At the moment, painting is a stand in for my job that's on hold because of Corona restrictions, so there will probably be no progress until next week. I just wanted to set up everything so I can start right away!
I am not good at telling stories on paper. my mind races far ahead of where the story wants to go and I never get it right so I will let the diorama tell itself. this is an original copy of the Clutch of Fear produced by Ral Partha in the early 1990s. The piece is high lead content. so soft infact that without some strategic pinning the joints fail (or so I have been told).
The basic story is that 2 egg thieves come to relieve a mother dragon of one of her eggs and she comes back early catching them just as they are leaving. The setting on the box seems to be some type of sulfur spring or volcanic hot spring and I get the impression of stillness of morning broken only by the shriek of an enraged mother.
I went pretty classic on this one, going with the red dragon and robin blue eggs like the box art but decided that the spines and chest plates should be more contrast than the slightly darker red of the box. I took the original base pieces included in the box and expanded them to a small diorama of a hotspring using Magic water, a transparent epoxy to create the water around the spring. The resin developed a little bit of a lip at the edge but I wasn't willing to cut it down and risk the clarity of the water by trying to sand and polish the resin. (its more rubbery that solid and difficult to polish -- I tried on two sample pieces and it didn't work out well.)
anyway the WIP is here if your interested: https://forum.reapermini.com/index.php?/topic/94482-a-new-year-a-new-old-dragon/
and here are the images of the final project. Hope everyone has as much fun looking as I did creating this. Feel free to comment and question away as always. The project was a lot of fun and the they got the expression of the egg thief who is looking back to see an enraged mother dragon bearing down on him just about right!
One shot from the human's perspective to give an idea of the trouble they are in....
And one from a mothers perspective as she hones in on the ones who are trying to steal her precious eggs!
Who's Online 10 Members, 3 Anonymous, 36 Guests (See full list)