Jump to content
  • Optionally enter a message with your report.

    ×   Pasted as rich text.   Restore formatting

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By MoonglowMinis
      Couldn't find a better thread to post this in.  Has anyone else ever had mold grow on their minis?
       
      I have a set of bones that have been sitting around for about two year. They were super glued to a reaper base. Baking soda and super glue were used to blend the integrated base into the round base. There's also a layer of cheap craft paint as primer.
       
      These guys have been sitting on my painting table in a former sun-room for about two years. 
       
      I noticed the bases had yellowed a bit, which I've begun to notice on some of my other older bases using baking soda as a basing material. But when I checked on them I noticed small fuzzy looking orange tufts. 
       
      I can only assume this is mold.
       
      The only things I could think of to cause this are the baking soda or the water used to clean my brush before priming. 
       
      Has anyone else seen this?
       
       

    • By Bruunwald
      I always love being reminded that we belong to one of the oldest traditions.
       
      Yes, this mini is 3,400 years old. And it came from a mold. And knowing what I know about ancient relics such as this, I would guess it once boasted bright colors.
       
      http://www.cnn.com/2016/02/25/middleeast/israel-boy-finds-ancient-figurine/index.html
    • By nakos
      So last night I decided to try my hand at using a wet pallet. I gathered my supplies, the plastic packaging and sponge from a Dark Miniatures mini and some Reynolds Parchment paper. I loved the ability to drag colors towards each other and blend them or using my brush to load and drop paint into each other.
       
      I don't remember where I saw the easy build with lid wet pallet construction thread here but it talked about using the sponge in the miniature package and to keep the water level just below the top edge of the sponge. In all the threads about construction it was mentioned over and over again to make sure to wet both sides of the parchment paper.
       
      Construction went well. It was easy enough to trim the sponge and the paper. I filled the palette with water and then soaked and squeezed all the air out of the sponge before placing the sponge in the palette. I poured off enough water to keep the water about a 1/4" below the top of the sponge. I then dipped the parchment paper for a few seconds in a cup of water to make sure I didn't get the curling edges effect.
       
       My problem is that paint still dried at the normal rate as if using a dry well palette. Did I use the wrong kind of sponge? Paper? Water level too low?
       
      Help? As I loved the way I could quickly mix glazes on the fly to adjust what my colors are doing.
  • Who's Online   15 Members, 2 Anonymous, 23 Guests (See full list)

×
×
  • Create New...