Recently Browsing 0 members
No registered users viewing this page.
I'm working on a conversion for my partner's character in our Swords and Wizardry campaign. She's a half-elf rogue with red hair that dual-wields swords, but unfortunately Reaper doesn't sell an exact figure of that type. There are a couple of other figures that might have worked but we both really liked Lanelle's base, so I took on the task of converting her to wield two swords and carry a shield on her back.
The sword conversion wasn't too difficult; I bought three copies of Lanelle so I could take the sword from one and have a third as a back-up in case I messed something up. I carefully snipped off the sword, and used a pin vise to attach it. I used the baking soda and superglue combo to patch up a few small gaps. The shield was harvested from a 77024 goblin mini, and has a little pin in it which will attach to her back. I'm keeping them separate for now to ease painting.
The original figure; this is the backup.
The successful conversion; the red hair is stained from a previous attempted paint job that was removed with Simple Green.
You can see the gaps a little on this side, but they've very minor and I believe paint will help disguise it later.
There are no visible gaps on the outside.
The shield will be attached right in the center of of her back; if positioned correctly I think it'll
just reach the sheath on her belt and give the illusion that the dagger is just hidden behind the shield.
The donor shield and unhappy goblin; I think this mini will make a nice battle-scarred goblin with a tragic past.
This is the latest Kickstarter project, expanding our fantasy range this time, and bringing light to the ones we have that might not have been noticed. Along with some super cool female minis, we have some brand new scenics too, and a whole bunch of add on bundles.
I'll post more on the lead up, but for now if you're interested, could you click the "notify me" on the pre launch page and it will help the algorithms, and you know algorithms are the new gods!
Next in line: 77049, Bones Arthrand Nightblade, Elf Ranger.
I tried priming with a 1:1 mix of Blue Liner:White Brush On Primer. There were a few mold lines and casting valleys that showed up. I put a layer of Brush On Sealer on them. We’ll see how that worked.
Venomous Flowers by PrintYourMonsters. These are 3d resin prints. Of course, they might also be only harmless spring flowers on some sci-fi world.
The smallest one is a bit over 1" across, the largest is taller than a humanoid figure. Overall I've been very happy with the Plants and Rocks files.
Who's Online 12 Members, 1 Anonymous, 31 Guests (See full list)