Jump to content

MojoBob
 Share

Recommended Posts

2019-01-14-Hag_DuncanLouca.jpg

 

This is one of Duncan Louca's Hags, printed on my Ender 3 (0.08mm layer height, eSun PLA+, total height to the top of the spikes is 44mm).

I got quite a lot of zits and boogers from the supports on this one, but she's so warty and festering that rather than trimming them off, I just turned them into zits and boogers.

  • Like 22
Link to comment
Share on other sites

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...