Recently Browsing 0 members
No registered users viewing this page.
Ok, so next week I'm gonna be replacing the LCD in my printer finally, but I'm also gonna replace the noisy fan on the very bottom of the printer. I finally found a good shot of the guts from the bottom:
Now the fan I ordered a few months ago is definitely not the one I need as it's one of the filter fans. So I'm gonna have to order a fan this week. That is why I'm posting here. What fan is good for this?
I've read where someone has modded theirs to run a 120mm fan, I just wanna do a direct replacement of it. One caution I have is the connections. Does the fan just clip into one of the white connectors or is it one that the wires go into the posts that screw down (like on a Ender 3)?
Funny how now I find this site vs trying to find anything these past few months:
(note the fan wire, it clips into one of the white connectors (yeah!!)
Any help will be appreciated for this.
I received this little 3D print with some minis I bought near the beginning of me getting back into painting. I looked at it and thought it was soooo cool. Now that months have gone by and I've got more of an eye for things I like and don't like, it became immediately apparent that this thing had a number of flaws.
1. 3D print left that weird topographic build quality to it.
2. The paint has a weird time adhering to it because of the lines in the model
3. The size of it is WAY out of proportion for 28mm, unless those are actual full size trees and this is a campfire for giants.
Overall it's just not a very good model. Yet, it was something that was sitting there calling me out and needed to get painted. I'll find some use for it, but I honestly think it came out pretty decent. I used a Stormy Grey from MSP on the rocks w/ GW Agrax Earthshade. On the wood I used a chocolate brown and brown sand mix (leftover on the palette...just went for it) with a GW Sepia Wash. Then I used flat red inside the burning log, highlighted up with a lemon yellow and flat red mix, then highlighted again with lemon yellow. Then dotted with white. The log was a little on the light side after the first wash, so I took Nuln Oil to it and dulled it down, which worked and gave it that more dark colored effect. The whole thing looks like it's actually warm when I'm looking at it, so the effect worked! I'm pretty happy with it. Now I just gotta find an ogre or giant to put it with....
How do you make an octopus laugh? You give him ten tickles!
Wanted to show off this little octopus that I sculpted from some leftover green stuff. I don't have much experience with sculpting other than a few simple embellishments on minis and a couple of snake swarms I made once. Wanted to try something relatively simple and figured an octopus would be pretty forgiving.
You can see more about how I made this guy and more of my nautical minis in my Dark Tide WIP thread HERE.
I sculpted and painted this guy in two evenings and am happy with hos cute it turned out. It's not the most accurate, but I'm proud of it. It definitely has given me greater confidence in my ability to make something out of nothing.
More Photos Beneath the Spoiler:
Who's Online 3 Members, 1 Anonymous, 98 Guests (See full list)