Recently Browsing 0 members
No registered users viewing this page.
The female changed from being a Storm Giant to being a Cloud Giant between the kickstarter and the retail release of the miniature. Whatever the subtype, she still gets a case of Smurfette syndrome.
The pose of the female is a bit strange, and she does have a certain supermodel-vibe going on. Reaper has explained that the pose was meant to illustrate her bending down to talk to someone human sized, and as such it is not too bad. But taken out of context it just comes off as a bit cheesecake-ish. Reaper has acknowledged that the pose did not work as intended. The swimsuit-like corset really does not help to avoid this impression at all.
Again, a mini with a slight case of bendyweaponitis. (which, in fact, is the proper scientific name for it). Treated with hot water then cold to straighten out the worst of it.
I based her on a 50mm round lipped base.
77162 Yephima, Female Cloud Giant (the male one did not get a proper name, I wonder why not?)
From the first Bones kickstarter, 2013
Storm Giants subset.
sculpted by Patrick Keith
50mm round lipped base
available from reapermini.com
A Wereboar in full charge mode. No wonder King Robert got the worst of his drunken encounter in the woods.
This one was started via a case of "I have some exess paint on my palette", this time I had a mishap and squeezed out far to much skintone at one point. And as I can't really get the paint back into the bottle, I needed to find a use for it. Hence this.
This wereboar is AFAIK as of yet unreleased for general sales by Reaper, so I do not have a SKU code for it. It came in a set with the werewolf I did not too long ago, and weregorilla(!).
I based it on a 45mm 3D printed base.
I hope it does not droop any more, but I fear it will as so much of the mini's mass is to the front, with only the single back leg to support it. Time will tell.
I'm participating in the Thanksgiving paint challenge. Here's my first figure.
I really wanted to do better with the gems and her crown. There's a large seam line through her hair from side to side.
I thought I should get some 22 gauge copper wire and create a circlet for her to hide it.
The white fur on the edge of her armor isn't wonderful either. So much to learn!
I've run out of steam on the figure so that will have to wait for later.
Thanks for looking
77162: Yephima, Female Cloud Giant
Who's Online 43 Members, 4 Anonymous, 191 Guests (See full list)
- Painting Dog
- Cranky Dog
- Dilvish the Deliverer
- Green Eyed Monster
- Darsc Zacal