Recently Browsing 0 members
No registered users viewing this page.
So after a substantial break from painting I purchased a new toy….a resin 3D printer (as I don’t have enough unpainted minis). So far I have enjoyed printing some minis even though my favorite will always be pewter.
My first choice to paint of the batch I printed to knock off the rust was this pretty lady Nihae. I printed her at 87.5% as Artisan Guild is too large to suit the rest of my collection. She is about the size of a standard reaper mini printed at this scale.
I printed some ferns and quickly put her on a base so she is ready to hit the table sometime soon.
Aline The Bold from Artisan Guild
3D printed on my Elegoo Mars.
Not happy with this one, the primer made her gritty, it took me a long time to finally finish her.
Oh well, another mini done, not my best stuff but her she is anyway.
I have been slightly less of a workaholic in May than in April, so I have been able to do some quartely challenges as well as the monthlies. I am probably not going to be able to paint anything else this month, so here goes.
These were all painted for the Reaper challenge league May, and again, squeezed in between work. So, low effort speed painting is the key. which also shows that is it possible to get quite decent results in a short time as long as you accept there will be some rough bits.
there are some pictures below
Who's Online 27 Members, 0 Anonymous, 25 Guests (See full list)
- Grumpy Gnome
- Pezler the Polychromatic
- Dan S
- Rob Dean
- Disciple of Sakura
- Knight of the Dinner Table