Jump to content

Recommended Posts

Hey all.  I have an Iwata Eclipse hp-cs that has been used fairly lightly for less than a year.  Recently, I had some issues where it was only pushing paint through while the needle was moving, but not when pulled back fully.  I emptied and cleaned everything, and have tried running just plain water through it, and it's now lightly bubbling up into the cup while the trigger is fully down and back.  I've cleaned the nozzle quite thoroughly, and I can't seem to figure out what else might be causing this.  Thoughts?

 

Thanks!

  • Like 1
Link to post
Share on other sites
  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...